Gunvault MVB 500 Manuel d'utilisateur télécharger pdf (Page 7)

- 6 -

Key Access

NOTE: Key Access is intended for backup use only.

Insert the key into the front of the unit.

Turn clockwise to unlock the unit.

Lift the top of the MicroVault Biometric to open.

To remove the key, close the MicroVault Biometric, turn the key

counterclockwise.

DELETING USERS/RESETTING THE UNIT

NOTE: Individual users cannot be deleted from the MicroVault Biometric. All

users will be deleted together.

To delete all fingerprints currently stored on the MicroVault Biometric,

press and hold the Delete Button, the LED will turn red, and then press the

Start Button.

The unit will beep twice and the LED will flash green twice, indicating all

users fingerprints are deleted. If no fingerprints are stored, the red led will

flash once and beep once.

Replacing the Battery

NOTE: Low Battery Warning - When the unit is powered on, if the LED flashes

red and the unit beeps 3 times, this indicates a low battery.

Pull open the battery cover.

Pull out the battery holder, by gently pulling on the ribbon.

a) Remove all old batteries.

b) Insert new 9v battery, following the Positive (+) and Negative (-) guides

on the holder.

Reinsert the battery holder and snap the battery cover back into place.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Gunvault MVB 500 Manuel d'utilisateur Page 7